LPS – All in One


The LPS has built-in lithium batteries
The LPS is compatible in cars and vans with Euro 6
Power supply for power tools, battery chargers and DC equipment
Use 230V/50Hz and 12V anywhere.

Charge automatically while driving using the car’s excess energy
– or connect directly to the mains.



LPS - 100Ah Lithium Ion Battery
12V – 1,05 kWh
Lithium Ion Battery
LPS - 1500W Sine Wave Inverter
230V/50Hz – 1500W
Pure Sine Wave Inverter
LPS - Intelligent Charger
230V/50Hz – 12V/50A
Intelligent Charger
LPS - DC-DC Booster, charging from an alternator
DC-DC Booster

LPS - Lithium Power Supply input/output

Easy access to energy

Use 230V/50Hz and 12V simultaneously – anywhere

Use 230V for your power tools, battery chargers and other electrical appliances, up to 1500W – and stable 12V energy for installed equipment – without being dependent on your vehicle being in expensive and polluting idling.

Charge automatically while driving using the car’s excess energy or connect directly to the mains. The LPS automatically charges and disconnects when the car is turned on and off.  

The built-in DC-DC Booster raises the voltage allowing cars with Euro 6 (reduced charge voltage) to charge the LPS efficiently.
Apply and charge the LPS in short cycles, without affecting the long life span –opposite traditional lead batteries.

Small & Robust

Simple installation in cars, vans, cottages and boats 

– easily disengaged, brought along and used as a generator.

The LPS is connected directly to the starter battery with a single cable utilizing the car’s alternator while charging.
Handle and plugs make it easy and quick to bring or replace the unit.
Dimensions: 24,5 x 25,5 x 39 cm
Weight: 28 kg

Userfriendly & Convenient

LPS - Consumption
Overview of remaining operation time

Through a clearly laid-out/easily comprehensive interface the remaining operation time is displayed.

LPS - Charging
Overview of remaining charging time

The remaining time to full charge is automatically shown when the unit is connected to a charging source.

LPS - Wake-Up
Automatic wake–up and shut–down

The unit automatically wakes-up when a charging source is connected. When disconnected, the unit will automatically shut down.

LPS - Starting Aid
Built-in starting aid (extras/optional)

If the automotive battery is discharged, the starting aid is activated through the display and you will be on the move again in no time.

Only 30% battery capacity is used at 500W consumption for 30 minutes
– drive only 30 minutes and the LPS is fully charged again.

Charge automatically while driving using the car’s excess energy or connect directly to the mains.
Secured against deep discharge

Safely use the full capacity of the lithium battery –the life span is insured by the built-in BMS controller.

The green "generator"

Zero CO2 – Zero noise

With a lithium battery based solution, it is possible to completely remove the need for idling. This means remarkable savings in gasoline and CO2 –and it creates a pollution-free working environment for your employees.


Secured against shorts

The only battery on the market that can short– circuit with no danger to the function or user of the product.

Secured against overheating

With an integrated BMS control, the battery is protected against overcharge so overheating is avoided.


230V/50Hz – 15 minutes: 1500W
230V/50Hz – continuously: 1300W
230V/50Hz – peak: 3000W
12VDC output: 70A
Operating times
200W@230V: 4hr : 30min
500W@230V: 1hr : 45min
1000W@230V: 50min
Charging times
Mains (50A): 1hr : 40min
Alternator (45A): 1hr : 45min

SRP (Suggested Retail Price) excl. VAT: €2.250,-

Great benefits with the LPS compared to traditional battery systems

Lithium vs AGM lead acid batteries

Powerful lithium

With more than twice as long operating time, the LPS clearly outperforms traditional lead batteries.

6x faster charging

One full charge of an LPS can be done in 1 hour 45 minutes - Much faster than the 8-10 hours needed for a lead battery.

6x longer lifespan

The LPS last 6 times longer with 2000 charge/discharge cycles than 350 for traditional lead batteries and the LPS requires no maintenance.

Compact design and low weight

Only 1/3 the weight of lead batteries with the same amount of available energy.

Fuel saving, silent and CO2 friendly

With the LPS it is possible to use energy without engine idling. This reduces the consumption of expensive fuel and zero CO2 is emitted.

Quick, simple and easy installation

All 12V DC and 230V/50Hz equipment is directly
connected to the LPS

The LPS is secured and connected directly to the automotive battery with a 16mm2 cable.
Anderson and Neutrik connectors for 12VDC and 230V/50Hz are included.

Find your Lithium Power Supply (LPS) dealer at www.lps.energy 

Specifications | Lithium Power Supply (LPS)


Lithium Power Supply (LPS) LPS 1512-100Ah
Model no. 014-01002GF
Battery type Li-Ion 12V – 100Ah
Battery chemistry LiFePO4
Battery capacity 100Ah (1320Wh)
Available capacity 80Ah (1050Whr)
AC Input Voltage 207 VAC – 253 VAC
AC Input frequency 45 Hz – 65 Hz
AC Input power (Charge power) 1000 W (4,5A)
AC Output voltage 230 VAC pure sine wave
AC Output frequency 50 Hz
AC Output power Continuously 1300 Wrms (6A)
AC Output power 15 min 1500 Wrms (6,5A) - 1800W (8A) / Socket
AC Output power Peak (10sec) 2500 Wrms
DC Input voltage 12 - 15 VDC
DC Input continuous current < 50 A
DC Output Voltage 13,2 VDC (9,2 - 15 VDC)
DC Output continuous current 60 ADC
DC Output Max Impulse current 20 min 70 A
1 min 100 A
10 Sec 150 A
Operating temperature (Output will be limited below 0°C) -20°C~50°C
Cooling Forced air (fan)
Self-discharge rate per month (Sleep mode) < 3%
Operating mode self consumption (Only DC Output active) 5 W
Operating mode self consumption (Inverter and DC Output active) 22 W
Sleep mode consumption < 25 mW
Connection 230VAC Neutrik and Schuko
Connection 12VDC Anderson SB50
IP rating IP21
Product Weight 28 kg
Product dimensions in mm (HxWxL) 250x244x390
Package weight 32 kg
Package dimensions in mm (HxWxL) 350 x 355 x 495
Approvals and standards
2014/35/EU (Low voltage directive)
EN 60950-1:2006 + A1:2010 + A2:2003 + A11:2009 + A12:2011 (Safety, Information technology equipment)
2014/30/EU (EMC directive)
EN 61000-6-3: 2007 + A1:2011 Emission household equipment
EN 61000-6-2: 2005 Immunity industrial